 |
STANDARD
8MM SILENT & SOUND MOVIE PROJECTORS
Updated
May 7, 2008 |
|
Scroll
down this page 
to see the 8mm movie projector models available.
8mm silent and sound movie projectors on this page are for standard / regular
8mm film only (unless noted). You cannot run super-8 movies on an 8mm projector.
If you need a Super-8 Projector, click HERE .
See the difference between 8mm
and super-8 film.
All projectors are Fully
Refurbished; thoroughly inspected, adjusted, lubricated, parts replaced
and repaired as necessary to restore to factory new running condition. All are
guaranteed clean and in perfect running condition with a good bulb and take-up reel. All
are 400' reel capacity unless noted. Excellent for showing your films or to transfer them
to video (using your video camera to capture the projected image). Every projector will
come with a new 200' 8mm cartoon and instruction book. A number in ( ) brackets indicates
if I have more than one of that projector.
Most of the projectors here are
excellent to use for transferring film to video, but none have the capability of
transferring the image to video through a line output. You must use a video camera to take
a picture of the projected image if you plan to use the projector for video transfer.
PLEASE VIEW WARRANTY AND RETURN
POLICY
IMPORTANT NOTE - RETURN POLICY:
All projectors are guaranteed to be as described and running perfectly for a full 30 days
after delivery date, or I will repair it or replace it for another comparable model. If I
don't have a satisfactory replacement, I will give a refund.
Please be sure about the type projector you need and what you order.
If, after you first receive a projector, you want to return it for a refund because you
bought the wrong format, thought it did something I indicated in the description or on the
page heading that it does not do, or you just decided you don't want it after all, I will
issue the refund less the initial shipping, Paypal fees if that applies, plus a
re-stocking fee of 25% of the selling price of the projector.
STANDARD
8MM SILENT MOVIE PROJECTORS |
 |
BELL
& HOWELL 370 LUMINA 1.2
ZOOM 8MM SILENT PROJECTOR
- With automatic threading through the film gate, 400' reel capacity, reverse and
single frame projection, variable speed control, retractable power cord. A bright picture
with the fast f1.2 zoom lens and low-volt DLS or DKR 150 watt bulb. Has a two position
lamp brightness switch to conserve lamp life for a small image or for transferring film to
video; or for a brighter image when showing a large picture. Like New condition with film
splicer, splicing tape and instruction book -
$449 (No
Discount)
|
BELL &
HOWELL 383AY LUMINA 1.2
ZOOM 8MM SILENT PROJECTOR
- The
most full-featured model ever made by Bell & Howell, from 1965. Has automatic
threading, 400' capacity, reverse and single frame projection, variable speeds in both
standard (approx. 15 to 25 fps) and slow motion settings. The shutter switches from 3 to 6
blades for flickerless slow motion down to 3 frames per second. A bright picture with the
fast f1.2 zoom lens and low-volt DLS or DKR 150 watt bulb, two position lamp brightness
switch, retractable power cord and room light control. Runs like a dream and in excellent
condition with instruction book and splicer - $499 (No
Discount)
|
 |
 |
SEARS (BELL
& HOWELL) 9280 AUTOMATIC
8MM SILENT PROJECTOR
- Here is an exceptional silent projector for bright big screen projection or for
video transfer. Features 400' reel capacity, variable speed control (approx. 15 to 25
fps), single frame and reverse, automatic threading to take-up reel, retractable power
cord, room light control and a very bright image for big screen projection using the low
volt DLS, DKR or DHX 150 watt bulb and the fast f1.2 lens. With instruction book,
film splicer and presstapes. Excellent+ - $449 (No
Discount)
|
SEARS (BELL
& HOWELL) 9289 ZOOM AUTOMATIC
8MM SILENT PROJECTOR
Sears top-of-the-line silent projector for bright big screen
projection or for video transfer. Features 400' reel capacity, single frame and reverse,
automatic threading to take-up reel, retractable power cord, room light control. Variable
speeds in both standard (approx. 15 to 25 fps)and slow motion settings. The shutter
switches from 3 to 6 blades for flickerless slow motion down to 3 frames per second. A
very bright image for big screen projection using the low volt DLS, DKR or DHX 150 watt
bulb and the fast f1.2 zoom lens. With instruction book. Runs beautifully and Near Mint
condition - $499
(No Discount)
|
 |
STANDARD
8MM MAGNETIC SOUND MOVIE PROJECTORS
 |
SEARS
(BELL & HOWELL) 8MM MAGNETIC SOUND PROJECTOR
- The Sears Soundstage projector runs regular 8mm sound or silent films. You can
record audio on the magnetic stripe along the edge of the film and playback sound films,
including commercial sound features and short subjects available at this site. Features
400' reel capacity, set speeds of 16 or 24 frames per second, single frame and reverse,
automatic threading to the take-up reel and a bright image using the DCH, DJA or DFP 150
watt bulb and f1.6 Zoom lens (not shown in picture). Instructions inside of the side
cover. Like New condition and runs beautifully; with microphone, instruction book, and
sound film - $999 (No Discount)
|
EUMIG MARK-S
ZOOM 8MM MAGNETIC SOUND PROJECTOR |
From 1965, this is the best performing regular 8mm sound projector
made. In many ways I consider this model superior to Eumigs later super and dual-8 models.
Totally refurbished with new motor mount bushing supports; and with brand new rubber
surfacing on the two drive discs, which are the heart of the mechanism. This was achieved
by much trial and error (and costly) experimenting to find the exact type and consistency
of rubber required. Has automatic threading through the film gate; manual
threading through the sound head to the take-up reel. Shows sound or silent film much
better and safer than the dual-8 models. Has pilot lights that come on when the projection
bulb is off for easy threading in the dark. Runs in forward and reverse. Has a variable
speed control for speeds from 15 to 25 frames per second. This makes it excellent for
electronic image transfer to the computer or DVD, without flicker at 20 fps, through a
video camera. Uses the inexpensive FCR 12 volt 100 watt bulb. Almost all steel and metal
construction with an excellent well built f1.3 zoom lens. Operates at 110 to 250 volts.
Comes with 400' take-up reel, protective hard plastic cover, instruction book, microphone,
spare bulb and commercial sound film - $1399
(No Discount)
|
|
|
EUMIG
MARK-S 709 DUAL-8 SOUND PROJECTOR
- Eumig is the only manufacturer to make a dual-8 sound projector. It will show both
8mm and super-8 sound or silent films. Handles both film formats well because of the
separate sprockets and film gates supplied, which are stored neatly inside the protective
cover. You simply switch the parts out when changing film formats. It has automatic
threading through the film gate, then you manually thread the film through the sound heads
to the take-up reel. This makes it very easy to unthread in the middle of a reel. Has
variable speed settings from 16 to 24 frames per second, 600' reel capacity and a bright
image with the f1.4 15 to 25mm zoom lens and inexpensive, 50 hour life, FCR 12 volt 100
watt bulb. Runs in forward or reverse. Comes with instruction book and with a super-8
sound and 8mm sound film so you can test it out right away. Near Mint with totally
refurbished rubber drive discs and new motor mounts - $1399
(No discount)
|
 |
- EUMIG DRIVE PULLEY FOR MARK-S 8MM
MODEL PROJECTORS - This is the main drive assembly for forward and reverse for the
Eumig Mark-S 8mm sound projector. Can also be used with other 700 series super-8 models
(smaller diameter worm gear will be installed for these models). Totally refurbished with brand new rubber
surfacing on the two drive discs, which are the heart of the mechanism. This was achieved
by much trial and error (and costly) experimenting to find the exact type and consistency
of rubber required. If you are having a problem with your projector maintaining the speed
and going too slow or not going at all, then this will solve your problem and make your
projector run like new again. - $299
|
- Also a Eumig Drive Pulley with the extended shaft for
Super and Dual-8 models 701 to 824 - $349 AVALIABLE SOON
NOTE: The inching knob on the 700
and 800 models is the knob on the extended shaft of the drive disc assembly. It comes out
the back of the projector and has the small knob on it you can turn to advance the film
manually frame by frame. The one for the Mark-S standard 8 is the same except it doesn't
have the extended shaft that comes out the back of the projector, however it would also
work on the 700 and 800 models (with the nylon worm gear exchanged).
|
For spare projector bulbs,
check my BULBS page. If I don't
have what you need, there are links there to other bulb and lamp sites.
** All
Projectors On This Page Are For Standard/Regular 8mm Film Only Unless Noted **
[ Up ] [ 8mm Projectors ] [ Super-8 Projectors ] [ 16mm Projectors ] [ Movie Supplies ] [ Projector Bulbs & Lamps ]
|
